The fireplace surround had reinforcing steel mesh embedded 1-inch into the surface. Since it is such a long piece (about 7 feet) which is restrained by the existing fireplace, the steel helps prevent shrinkage cracking. Even though the carpet here will get replaced it was covered with cardboard. Integrally mixed concrete pigment will stain pretty much everything.
The setup in the garage. The fireplace took 3.3 cubic feet of concrete so two different batches were required. The mixture was a modified quikcrete mixture containing lower w/c, latex, high range water reducer, viscosity modifier, fibers, and pigment.
Same mixer as last time, still too small. Each batch was 1.65 cubic feet.
The mixture was self-consolidating to minimize honeycombing against the small gap between the mold and the fireplace.
The surface was hard-troweled and covered with plastic.
And covered with wet towels for a couple days.
No comments:
Post a Comment